|
26/07/2010
tonyd (100%)
Can you use this with a HET 6904 fan?
|
|
|
 |
|
|
 |
|
|
4/09/2009
Walter (34%)
I have the same problem as TRXTC mentioned. Which prop adapter you are using with a e.g. 5.5x4.5 APC Prop? The hole-diameter of these small props is 6mm but I can not find an adapter for the 5mm motorshaft which has a 6mm prop shaft. Can anybody help me to find the right one?
|
|
|
| |
|
vasy1
(59%)
rim out a large hole in the prop.
|
|
|
|
Was this the best answer? YES | NO
|
|
| |
|
trxtc
(66%)
the same problem i had, these props can not be reamed out because there is not enough plasic on prop.
So wat i ended up doing is getting a 7" prop and cutting it down to the size i needed and balancing, works beautifully
|
|
|
|
Was this the best answer? YES | NO
|
|
|
|
|
|
|
|
11/08/2009
Omid (85%)
Is it more than 12 poles?
|
|
|
|
|
|
|
|
|
3/07/2009
trxtc (66%)
how do these people get these small props on 5mm shaft my prop adapter is 8mm ED, 7" prop is the smallest i can put on
|
|
|
| |
|
Charles
(85%)
you use a prop reamer and open up the hole to fit the dia of the prop adapter you are using. Make sure to also use the suitable sized ring that comes with the props.
|
|
|
|
Was this the best answer? YES | NO
|
|
|
|
|
|
|
|
4/04/2009
Arthur (79%)
Anyone run this motor on 5s? Or 6 A123's?
Thanks,
AW
|
|
|
| |
|
vasy1
(59%)
The motor is rated for 710 or so watts, with 4 cell and 6 inch prop you are hitting the max watts.
Sounds like 5s is a little too hot, it will work but you might fry it.
|
|
|
|
Was this the best answer? YES | NO
|
|
| |
|
vasy1
(59%)
4s on 6 inch prop is not good... yields one fried motor. I was only pushing about 950 watts for a few seconds and the motor just went up in smoke... so when they say 710+ watts, they mean 711... :(
so if you need more then 700watts look elsewhere.
Maybe if you can do 4.75x4.75 on 4s but I didn't get a chance to try.
|
|
|
|
Was this the best answer? YES | NO
|
|
|
|
|
|
|
SHARKRUGS (67%)
is this motor suitable with walkera 22E?
|
|
|
|
|
|
|
