|
7/16/2010
Timothy (30%)
Has anyone tried one of these on the hk500gt as a tail servo???
|
|
|
 |
|
|
 |
|
|
5/19/2010
Warren (13%)
The torque figures in inch ounces are wrong assuming the metric ones are correct. The metric figures would convert to roughly 550 inch ounces at 8.4 volts and 780 inch ounces at 12 volts.
|
|
|
| |
|
Warren
(13%)
The original torque figures of 101 and 144 inch ounces shown in the specs appear to be correct after all.
|
|
|
|
Was this the best answer? YES | NO
|
|
|
|
|
|
|
2/28/2010
odam2k (39%)
Nobody order one yet? No reviews? I just ordered 3 to use on the TZ v2 .90 for Cyclic and the Turnigy BLS980 for the tail. Can't wait to get them and try them out....
|
|
|
|
|
|
|
|
|
2/11/2010
Flyitall (79%)
This servo is ALMOST PERFECT. 3s HV, Ti gears, alloy cnc case, but why not brushless? I will wait until the HK labs put that together, then I will buy MANY! Thank you in advance HK! (My preferred specs would be <.03sec/60deg * >12kg)
|
|
|
|
|
|
|
|
2/9/2010
zachjust (49%)
So the minimum I can use to make this work is 8.4v? I was hoping to use this for my truck but it looks like i wont be able to.
|
|
|
|
|
|
|
|
|
2/9/2010
jake26 (69%)
Wow 12 volts! thats crazy!
|
|
|
| |
|
xray mike
(59%)
> Operating Voltage: 8.4 ~12.0 V DC Volts
What kind of supply do you use with these servos? The operating voltage range is too high for 2S (7.4V nominal) and too low for 3S (12.6V fully charged). What am I overlooking?
|
|
|
|
Was this the best answer? YES | NO
|
|
| |
|
KAGE
(30%)
Good servo!
I got one today & test it on my RC car with 6.0 volt receptee from ESC and it works!!! Strong and fast! I almost broke my finger during the test =)
|
|
|
|
Was this the best answer? YES | NO
|
|
|
|
|
|
